injection mould for pitcher

-Product Material:Polycarbonate -Impression Surface Material:20 ‿28-32 Rc (German 718) -Finish (12.10):A-2 #6 diamond buff -Gate Location(s) ：Center of Cavity，Cavity bottom insert to have dedicated cooling line around the valve gate.Cavity bottom will have (2) die springs per lifter to assist with breakaway during mold opening. -Gate Size：TBD -Locating Ring (16.51)＿‿5‿flip flop design -Each lifter will be timed with (2) Thompson rods with bronze bushings. Rods to be 2‿diameter. -Lifters will have water for cooling. -Polish cavity after plating to remove all high spots. -Drilling Size＿/16‿Dia. -Each mold plate will have a lifting hole on each side of the plate. -Each Clamp plate will have (4) lifting holes on the platen surface of the plate. -All air poppet valves and pressed in pins will have access holes drilled through -mold and clamp plates to allow removal without disassembling mold.