Automotive mould

Construction: 2/3 plate, hot runner/sprue, over molding. Type of gate: Banana gate, pinpoint, hot tip/valve g, edge, direct, diaphragm, center sprue, tap gate, tunnel. Material: P20 (28-32 hrc), high hard p20 (32-36hrc), h13; Nak80, stainless steel, 420sst 42-44rc, prototype, s136. Finish: Spi / spe #d3, machined, polished, textured, specify mt, fine edm, mirror polish. Side action: Angle pin/heel/dog legs, hydraulic cylinder, cams/slides, collapsible core. Ejection: Pins. Blades, sleeve, stripper bar, air, special lifts, robot required. Mold features: Flush style k. O. Extensions, spring returned k. O., ejector stroke limiters, runner shut-off(s), locking locating ring, pressure sensor slot & plug, insulator plates, conical interlocks, parting line locks & cycle counter.